dark

PFsense and Wireguard Site to Site VPN (2022 Edition)

Total
0
Shares
0
0
0



I am going to show you how to configure Wireguard site to site VPN on Pfsense firewall.
We have two sites head office and branch office both are connected to internet with Static WAN IP address.
LAN on HO: 172.16.10.0/24
LAN on Branch : 192.168.20.0/24

I am going to use 10.6.210.0/31 address cause it has only two IP address on this Subnet

————-TimeLine—————–
00:00 Intro
01:16 Wiregaurd Package Installation
01:42 Create Wireguard Tunnel
02:04 Port Forwarding
02:26 Assign Wireguard Interface
03:27 Firewall rule
03:55 Adding Peers
05:55 Create Gateway and Static Routing

visit my site for more details: https://mapdr.tech/pfsense-wg/

📢 Discord Server
https://discord.gg/JHmzDXnNCG

6 comments

  1. Thank you for your video guide.
    For my setup, I had to add a static outbound rule that included the tunnel subnet. Otherwise some computers were unable to talk to each other from both ends.

  2. Thank you for your video. When I tested the configuration for the first time, I was able to successfully site to site, but when I dialed up PPPOE again (I have configured DDNS), I can no longer connect to the other party’s network on the PCs at both ends. It's over, all configurations are the configurations that were running normally before. I have also tried to reconfigure, I don't know how to find this to fix the problem, hope to get your help.🌻

Comments are closed.